CONTROL · 600V · SHIELDED MULTI-CONDUCTOR · 18–10 AWG
Control and Instrumentation Cable Buyers in New York
Control and instrumentation cable is small conductor, high pair count and frequently shielded — the material that fills a plant maintenance crib and never gets counted until a shutdown. It is reviewed on part number, pair count, shield type and length rather than on weight.
WHAT WE REVIEW
Control & instrumentation: what we review
Typical control cable is 18 through 10 AWG, two- through multi-conductor, 600 V, with numbered or colour-coded conductors and an overall foil or braid shield for signal work. Instrumentation cable adds individual or overall shields, drain wires and twisted pairs. Thermocouple extension, fire-alarm and low-voltage communication cable sit nearby in the same crib and are reviewed as their own categories when you identify them.
These are the cables where a part number is worth more than a photograph, because two cables that look identical can differ in shield, pair count and temperature rating. Send the reel tag part number and manufacturer, and photograph the print along the jacket. Where a cable is unidentified, say so — an unidentified control cable is reviewed as unidentified, and no one should pretend otherwise.
Formats accepted for review
- Full reels with part numbers and original wrap
- Partial reels from a shutdown or panel build
- Shielded instrumentation cable with drain wires
- Mixed part numbers sorted and labelled
What to send
- Manufacturer and part number from the reel tag
- Conductor count, gauge and numbering scheme
- Shield type — overall foil, individual pair, braid
- Voltage rating and any tray or sunlight marking
No offer is made until someone has read the jacket legend or the reel tag. If neither survives, the material is still reviewable — it is simply reviewed as unidentified, and the outcome reflects that.
INVENTORY SUBMISSION · RESPONSE BY EMAIL OR PHONE
Send control & instrumentation for review
Photographs of the reel tag and jacket legend are the fastest route to a review. Approximate footage is acceptable; a stated method is better than a confident guess.
REFERENCE
Control & instrumentation — questions sellers ask
Answers describe how material is reviewed. They are not an offer, a price or a commitment to purchase.
Do you review cable without a part number?
Yes, described as unidentified. The jacket print, pair count and a photograph of the cross-section at a cut end usually allow a reasonable classification, but the review will be more conservative than one based on a tag.
Is fire-alarm cable reviewed as control cable?
It is a separate category with its own approvals, and it should be identified as fire-alarm or low-voltage signal cable. Mixing it into a control cable count makes the review less accurate.
What length increments matter?
Control cable is often used in short pulls, so a 900 ft partial is more useful than a 40 ft tail. Give the length of each piece where you can, and group tails separately from reels.
WHO SELLS THIS MATERIAL
Where this material usually comes from
Most lots arrive from one of four places: a contractor closing out a job, a plant replacing equipment, a distributor clearing slow stock, or a demolition project releasing cable legitimately. Each is reviewed on the same facts.
STATEWIDE · NEW YORK
Have control & instrumentation to sell?
Send the tag, the jacket print and an approximate count. If the material is a fit, price and logistics are agreed in writing before anything is loaded.